Cerakote
Does Cerakote wear off? How long a Cerakote finish lasts on a gun
3 min read
Short answer: yes, Cerakote can wear. Long answer: a good Cerakote job on a gun that gets used will hold up for years, and when it does wear, it wears in predictable places. So the useful question is what decides how long.
Here’s how it works.
What Cerakote actually is
Cerakote is a thin-film ceramic coating. It goes on with a spray gun, roughly a thousandth of an inch thick, and then it cures. Once it cures, it bonds to the metal instead of sitting on top of it like paint.
That thin film is the point. It protects against corrosion and the chemicals you clean with, without stacking up so much material that parts stop fitting. It also means the coating is only as good as the surface underneath it.
Prep decides how long it lasts
Most Cerakote failures trace back to prep, not to the coating.
- Degreasing. Gun steel holds oil in its pores. If that oil isn’t pulled out first, it comes up under the finish later and the coating lets go.
- Blasting. The metal gets abrasive blasted to give the coating something to grab. Skip it or rush it and the finish can peel at the edges.
- Clean handling. One bare-hand fingerprint between blasting and spraying can leave a weak spot.
- Proper cure. The coating has to cure at the right temperature for the right time. Under-cured Cerakote looks fine on day one and wears fast.
Get those right and the coating does what it’s supposed to do. Get them wrong and no amount of color choice will save it.
Where it wears first
Even a perfect job wears where the gun rubs against something. Expect to see it first on:
- Edges and corners, like the muzzle and the front of a slide.
- Holster contact points, on a pistol that’s carried and drawn every day.
- High-touch controls, like the magazine release, safety and charging handle.
- Where parts slide against each other, if those surfaces were coated.
That’s normal. It is the same holster wear you would see on bluing or any other finish, and for a lot of owners it’s part of the look of a gun that gets used.
What can be fixed
Small worn spots can’t be dabbed back to factory look like touch-up paint. To do it right, the part gets stripped and recoated, then cured again. The good news is that Cerakote can be removed by blasting, so a worn part, or a color you’re tired of, can be redone without hurting the metal underneath.
If a single part is worn, like a slide or a handguard, it can often be redone by itself and matched to the rest of the gun.
How to keep a finish looking right
- Clean it normally. Cerakote stands up to the solvents and oils you already use.
- Wipe it down after a range day, especially in Texas humidity. The coating protects against corrosion, but uncoated parts underneath still need attention.
- Pick a holster that fits. A sloppy holster grinds a finish faster than anything else.
- Think about color. Some colors show holster wear and edge wear more than others. That’s a good conversation to have before the gun goes in the booth.
The bottom line
A well-prepped, properly cured Cerakote finish is one of the toughest finishes you can put on a firearm. It will show wear where the gun rubs, and that wear can be fixed. What decides how long it lasts is mostly what happens before the color goes on, which is why we walk through exactly what happens to your gun during a Cerakote job in a separate article.
We are a veteran-owned shop with a Type 07 FFL, Cerakote Certified, offering over 200 colors plus multi-color patterns, camo schemes and custom designs. We work out of NW Houston and serve Magnolia, TX and the surrounding area. See our Cerakote and other services, or send us your project and we will get back to you.
Thinking about a muzzle device while the gun is apart? Here’s what to know before you thread a barrel.